Glossary(595)

The number of needles in one inch (25.4mm).Reference value when converting length (cm) to number of stitches (dot).

The format used as compatible data by each automatic cutting machine manufacturer. If you create data in this format with another company’s CAD, it can be read by SHIMA SEIKI’s cutting machine. (* Some data may not be cut, so prior verification is required.)

A pattern composed of big lattices made by gathering small lattices.

When pattern pieces are dressed onto a 3D model, sometimes they get stuck in the 3D model or overlap each other. If the pattern pieces go through the 3D model, pull it out.

Information to input at points where you want to specify the amount of movement when grading. The notation is sometimes abbreviated as [GP]. Displayed as a number and linked to the row number of the pitch table to specify the amount of movement.

A line that indicates the direction of the fabric.

Extension of grading data used in PGM software. The contents of [Pitch Table] are saved.

Device to hold edge yarn.

Main part other than hem knitting and waste knitting.

The ground yarn of a towel fabric.

A group attribute is set for a project file created in SDS-ONE APEX, and it is displayed at the upper right in the thumbnail in the Picture Directory.

A point to use as a guide when drawing lines. Input when necessary for drawing, such as the position to be the start/end points of the line and the position where the line passes. You can input on-line or off-line.